|
|
- Identification
- Composition/Information on Ingredients
- Hazards Identification
- First Aid Measures
- Fire Fighting Measures
- Accidental Release Measures
- Handling and Storage
- Exposure Control/Personal Protection
- Physical and Chemical Properties
- Stability and Reactivity
- Toxicological Information
- Ecological Information
- Disposal Consideration
- Transport
- Regulatory Information
- Other Information
|
|
|
|
|
|
|
|
Preparation:
|
Nomix AGC
|
Supplier: |
Nomix Enviro Ltd, Portland Building, Portland Street, Staple Hill, Bristol BS16 4PS
T: 0117 957 4574; F: 0117 956 3461; E: info@nomix.co.uk |
Chemical Emergency Agency Service 24 hour: 01865 407 333 |
 |
|
|
Ingredient |
CAS No |
Classification |
Concentration % w/w |
Tetraethyl Silicate |
78-10-4 |
Xn R10,R20,R36/37 |
1-5% |
Isoparaffinic Hydrocarbons |
90622-57-4 |
Xn R53,R65,R66 |
30-60% |
Siloxane with functional groups |
|
Xi R36; |
30-60% |
|
Harmful by inhalation, may cause lung damage if swallowed. Irritating to eyes and respiratory system.
Top of Page
|
General |
Where symptoms persist, or if in any doubt at all seek medical help. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. |
Inhalation |
Remove from exposure keeping warm and at rest. Seek medical attention if irritation persists. |
Ingestion |
Do not induce vomiting except in the presence of or on the orders of a doctor. Rinse mouth with water and drink plenty of water. Seek medical attention. |
Skin Contact |
Remove any contaminated clothing. Wash the affected area immediately with soap and water. Seek medical attention if irritation persists. |
Eye Contact |
Irrigate the eye thoroughly with clean water for at least 10 minutes holding the eyelids apart if necessary. Seek medical attention. |
Top of Page |
EXTINGUISHING MEDIA
RECOMMENDED:
Alcohol resistant foam, CO2, powder, water spray.
NOT TO BE USED:
Water Jet.
SPECIAL INSTRUCTIONS FOR FIRE FIGHTING PERSONNEL:
Fire will produce dense black smoke containing hazardous of combustion (see section 10).
Decomposition products may be a hazard to health.
Appropriate self contained breathing apparatus may be required.
Cool closed containers exposed to fire with a water spray.
Do not allow run off from the fire fighting to enter drains or water courses.
Top of Page |
Absorb in vermiculite, dry sand or earth and place into containers.
Top of Page
|
Handling |
Prevent air-borne concentrations higher than the occupational exposure limits.
Observe label instructions.
Keep the container tightly closed.
Exclude any sources of heat, sparks and open flames.
Avoid inhalation of vapour. Smoking, eating and drinking should be prohibited in areas of storage and use. For personal protection see section 8.
|
Storage |
Observe label instructions. Store between 5 & 25°C in a well ventilated, dry place, away from sources of heat, ignition and direct sunlight. Protect from frost. Prevent unauthorised opening, containers should be properly resealed and kept upright. Store separately from oxidising agents and any strong alkaline or acidic materials. |
Top of Page |
ENGINEERING MEASURES
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust
ventilation and good general extraction.
EXPOSURE LIMITS
Substance name |
CAS No |
STD |
STEL 15mins |
LT Exp 8 hours |
Tetraethyl Silicate |
78-10-4 |
OES |
30ppm |
10ppm |
PERSONAL PROTECTION
General Protection
All personal protective equipment, including respiratory protection equipment, used to control exposure to hazardous substances must be selected to meet the requirements of the COSHH regulations.
Hand protection
Where skin exposure may occur advice from glove suppliers should be sought, on the appropriate type to use.
Whilst barrier cream may help to protect the skin it is not a substitute physical protection. It should NOT be used after exposure has occurred.
Eye Protection
Eye protection designed to protect against liquid splashes should be worn.
Skin Protection
Cotton or cotton/synthetic overalls or coveralls are normally suitable. Grossly contaminated clothing should be removed and the skin washed with soap and water.
Top of Page
|
Appearance |
Viscous liquid |
Flash point |
N/D |
Specific Gravity |
0.9 |
Vapour Density |
Heavier than air |
Odour |
Mild (faint) |
Solubility in Water |
Insoluble in water |
Top of Page |
Stability |
Normally stable. Moisture curing process releases a small amount of Ethanol
|
Conditions to avoid |
Avoid excessive heat for prolonged periods of time.
|
Hazardous decomposition products |
Temperatures of > 150deg.C may generate a small amount of Formaldehyde |
Top of Page |
There are no data available on this product itself.
Top of Page |
There are no data available on the product itself.
The product should not be allowed to enter drains or water courses or be deposited where it can affect ground or surface waters. The Air Pollution Control requirements of regulations made under the Environmental Protection Act may apply to the use of this product. May cause long term adverse affects in the aquatic environment.
Degradability: Not degradable
Top of Page
|
Do not allow into drains or water courses or dispose of where ground or surface waters may be affected. Wastes including emptied containers, are controlled wastes and should be disposed of in accordance with regulations made under the Control of Pollution Environmental Protection Acts. Using the information in this Safety Data Sheet, advice can be obtained form the Waste Regulation Authority as to whether the special regulations apply.
Top of Page |
This product is not classified as dangerous for carriage.
Top of Page |
HARMFUL, Xn
R20: Harmful by inhalation
R36/37: Irritating to eyes and respiratory system
R53: May cause long term adverse affects in the aquatic environment
R65: May cause lung damage if swallowed
S-25 Avoid contact with eyes.
S-26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice
S-37 Wear suitable gloves.
Top of Page
|
Text of any risk phrases listed in section 2.
R10 Flammable
The information contained in this safety data sheet has been prepared in good faith by the company and represents the company’s actual knowledge at the time of issue. The purpose of this information is solely to enable the user to take necessary measures for the protection of health and safety at work. No warranty or guarantee is given as to the properties, specifications or quality of the product, or its use or application. The user must be personally satisfied as to the suitability or completeness of the information for their own use. It is the user’s responsibility to observe national or local laws or regulations as to industrial safety; in no case can the Company accept any responsibility for its users failure to observe such laws or regulations.
MSDS Dated: 02.11.05
Supersedes: 04.06.04
|
